Remove the protectiveĬover of the Hook side (Picture 2) and apply to desired mounting location. The Velcro tape can be separated to Hook and Loop side (Picture 1). On wall with cracking paint or rough surface. The Panic Button can be wall mounting using Velcro tape provided.Ĭlean the wall mounting location and back of the Panic button with degreaser. Successfully installed the Panic Button, please gently remove the Pad. There are two ways to deploy the Panic Button: Wall Mounting and Surface Deployment. The button accidently when mounting the Panic Button. (This function is not compatible with all control panels.)Ī Pad is included into the Panic Button as picture shown below. Press and hold the Button for 8 seconds or more will send a Cancel Code to the Control Panel The Panel will display the RSSi (Radio Strength Signal) strength.Īfter the Panic Button is learned successfully, press the Button to activate a Panic Alarm. Place the Control Panel in the walk test mode. Refer to your Control Panelâs operation manual to complete the learn-in process. Press the button on the Panic Button to transmit a learn code. Pull out the Battery Insulator to power on the Panic Button When changing battery, after removing the old battery, press the button twice to fully discharge Signal transmission to the Control Panel for display accordingly. The Panic Button will transmit any detected low battery status along with any regular status The Panic Button is powered by one CR123A 3V Lithium battery. The Control Panel will indicate that the Panic Button is out-of-signal range or is out of order. If the Control Panel has not received the signal from the Panic Button for a preset period of time, The Panic Button will automatically transmit Supervisory Signals every 30 to 50 minutes. (Thisįunction is not compatiable with every control panel). Press and hold the button for 8 seconds to send a Cancel Code to the Control Panel. Press to send a learn code or activate a panic alarmĢ. The LED indicator will light up briefly when the device is transmitting a signal.ġ. The Panic Button is used to activate (or deactivate) a panic alarm.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |